What are the advantages of spray painting your car with compressed air? To start with, it can be a real money saver in the long term. There’s an investment required in the initial purchase of the tools, but once youve it then you start saving money on your projects from there on in. Other great advantage is youve more flexibility in the use of the compressed air. In todays day of age air pollution is a huge issue. Hence, the use of aerosol propellants are frowned upon. The best answer to this’s the compressed air sprayer.
Frequently people shy away from utilising compressed air sprayers because they think they are too difficult. This is not the case. Once you get a bit practice, utilising them there’s no way you’ll want to go back to the aerosol spray.
The best paint to use in these sprayers is enamel, but say you add up an appropriate conditioner to the acrylic and latex paints then you could utilize them successfully as well. This would permit the paint to flow the right way through the tube as it thins it down.
Established your working area the right way. Whenever youre going to do various kind of spray-painting there’ll be a certain amount of over spray. Take all the correct safety precautions. Do your work in a well-ventilated area. Wear a mask for sanding. Be sure to wear goggles or rather gloves.
Once youre all set up then you are ready to start. You will want to grind or sand off any rust and corrosion or rough spots. Then you must be sure the car is absolutely clean and dry before you begin the application. For oil based paints utilize mineral spirits, and for the latex ones soap and water would work fine, but rinse well.
If need be, prime the surface. Do your mixing of the paints and thinners youve chosen to apply. This could be a sloppy job, so protect the blending area with a drop cloth.
At present its time to switch on the air compressor. You want it to build up pressure while youre preparing your paint. You’ll need some of the air for priming and testing. If you look on the compressor, you should see a regulator. This will allow you to set the pressure you require for the sprayer. Say you don’t do this then the air flow will fluctuate and you’ll end up with unbalanced spraying.
Tie the hose coupling to the sprayer. It is important youve an air tight seal so be sure it is attached tightly and wrap the join with a few Teflon tape if you want.
Say you stick to the exact instructions that came with your original sprayer, it will walk you through each of the steps. To start with, practise the paint application on another object. This way you will get the feel of managing the sprayer and be able to judge the correct consistency of the paint application.
Tags: Sloppy Job, Aerosol Paint, Latex Paints, Goggles
